Advertisement
FM336 9800 TCWI1 Series
6.1
Important
1. Caution: Disconnect all input power before beginning installation to pre-
vent electrical shock and equipment damage.
2. Installer must be a trained, experienced service person.
3. All wiring must comply with applicable local electrical codes, ordinances
and regulations.
6.2
Installation Notes
1. With new applications, an ElectroLynx™ door harness with 8 and 4 pin con-
nectors will be pre-installed inside door by ASSA ABLOY door manufacturer when
specified during ordering process.
2. Wiring to pigtail harness is per facility wiring requirement. ElectroLynx™ connec-
tor terminations and wire colors all match.
3. If door does not have an ElectroLynx™ type door harness, cut connectors
off product and hard wire, or consult factory for appropriate mating harness.
6.3
ElectroLynx™ Connector System Notes:
The system is designed to be installation friendly with pluggable connectors from
the electric hinge through the door to the rail. The only wiring required is to the
loose wires on the pigtail harness assembly on the frame side of the electric hinge.
IMPORTANT:
The plug and receptacle connectors are designed to mate and lock together as
shown in the figure. Plug the connectors into each other with the locking mechanism
aligned as indicated.
Do NOT Force connectors on any other way.
6) Hard Wiring Instructions
Receptacle
Locking Mechanism
Plug
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express
written permission of Corbin Russwin, Inc. is prohibited.
11
Advertisement
