Advertisement
PICO-200 Table Saw
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
M
NSTRUCTION
ANUAL
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com
Web: http://www.metallographic.com
1.3 Features
Passive Cooling System
The PICO-200 has a passive cooling system.
The blade runs through the cutting fluid held
under the cutting table. This action cleans the
blade while also cooling it. The fluid on the
blade cools the part as it cuts.
Motor Feedback
The PICO-200 is quipped with a 200W motor
that has a feedback loop for maintaining cutting
velocity. This allows the PICO-200 to adjust
power and torque as needed to maintain blade
rpm. The circuit has overload protection to stop
the blade if too many amps are pulled. This
occurs when the blade gets jammed in a part or
if the manual feed is too aggressive.
East to Use
The PICO-200 is easy to operate with its simple
control scheme. Adjust rpm with a simple turn of
a dial. The manual feed wheel gives a nice
feedback to the hand while moving the blade.
Multi-Purpose Machine
The PICO-200 saw can be used dry or wet. This
allows the operator to determine the best way to
cut a specimen. With the magnetic over-ride
switch enabled the operator can manually feed
parts if needed.
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
3
Advertisement
