Advertisement
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com
4.2 Changing Wafering Blade
1. Lift the table and ensure the table locks in place
2. Using the provided wrenches (14 mm and 28 mm) hold the blade arbor and the
locking nut with their respective wrenches
3. Loosen the blade locking nut and remove it
4. Remove the blade and position new blade on arbor
5. Place locking nut back into arbor and tighten. Do not over tighten as this might
warp the blade
4.3 Positioning Sample
The PICO-200 has a large cutting table. Identify where the cut needs to take place
and position the part on the table in front of the blade. Use the vertical clamps to hold
the part down to the table. Ensure that the part will not move. Use your hand and
attempt to move it, if it slips at then tightening or repositioning is required.
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
PICO-200 Table Saw
I
NSTRUCTION
M
ANUAL
Web: http://www.metallographic.com
9
Advertisement
