Valeport 801 EM Operating Manual page 13

4.6.1. Change Date/Time
Selecting SET DATE/TIME at the LOGGING MENU reveals the following display.
< < < N E X T
T I M E : H H : M M
D A T E : D D / M M / Y Y Y Y
INCREASE Increases the currently selected number by 1.
DECREASE Decreases the currently selected number by 1.
NEXT Selects the next number in the time/date sequence.
EXIT Returns user to LOGGING MENU. Refer to Section 4.6.
4.6.2. Viewing Stored Data
Selecting VIEW DATA at the LOGGING MENU reveals a display similar to that shown below. If no
data has been stored, the message NO DATA STORED will be displayed.
# I D E N T
E M S E R N O . X X X X X
U N I T S X X X X X X
R U N M O D E
D D / M M / Y Y Y Y
< < < V I E W
The display shows the record number, serial number, units in which velocity is measured [metres or
feet per second], run mode, and time at which the record was stored [i.e. the end of the
averaging period].
UP Toggles the record to be viewed up by one.
DOWN Toggles the record to be viewed down by one
VIEW Allows user to view the record currently selected. A display of the format shown below
will be seen. Press EXIT on this screen to return to the VIEW DATA screen, allowing
another record to be seen.
EXIT Returns to the LOGGING MENU. Refer to Section 4.6.
C H A N G E
F F F R
X X X X X X X X X X X X X
H H : M M : S S
System Operation
D A T E / T I M E
I N C R E A S E > > >
D E C R E A S E > > >
Page 13
E X I T > > >
U P > > >
D O W N > > >
E X I T > > >
© 2016 Valeport Ltd