Logging Menu - Valeport 801 EM Operating Manual

Model 801 EM Current Meter
Page 12
SUB OPTIONS
EXIT

4.6. Logging Menu

Selecting LOGGING MENU at the OPTIONS MENU reveals the following display.
< < < S E T D A T E / T I M E
< < < R E S E T
< < < V I E W
SET DATE/TIME
RESET #IDENT
VIEW DATA
EXTRACT DATA
ERASE MEMORY
EXIT
© 2016 Valeport Ltd
to set the unit date and time. Refer to Section 4.6.
This enables the user to go into the sub – options menu which allows
direct EM communications with a PC [via data interface lead] for
viewing EM data and setting of the calibration coefficients. Refer to
Section 6. This sub-options menu also allows, if the options are fitted,
frequency outputs and alarms to be set.
Puts the unit into Run Mode, using the hardware configurations
selected [see Section 4.3].
L O G G I N G
# I D E N T
D A T A
Allows access to the CHANGE DATE/TIME screen. This allows the user to alter
the unit's internal clock, for the purpose of correctly time stamping the
recorded data. See Section 4.6.1.
Sets the memory pointer to record #1 and updates the series letter. For
example, a second series of records would begin with record #001B.
Allows user to see logged data. See Section 4.6.2.
Allows user to upload stored data to a PC. See Section 4.6.3.
Clears all stored data from the unit and resets data series identification to
"A"; it does not reset #IDENT to zero which has to be done by the RESET
#IDENT key, which should be done first otherwise the series B identification
will be set. A screen will appear, requesting confirmation that the user
wishes to erase memory. Press YES to continue, or EXIT to return to LOGGING
MENU. If YES is pressed, a message will confirm that memory has been
erased. Press EXIT to return to LOGGING MENU.
Returns user to OPTIONS MENU. Refer to Section 4.5.
M E N U
E X T R A C T
E R A S E
D A T A > > >
M E M O R Y > > >
E X I T > > >