VERDER JEC PUMPS JRZS Series Operation And Maintenance Manual page 16

6. On the opposite shafts, interdigitate carefully for both
screws together with checking the key and groove in shaft
to be matched, and insert properly to the shaft shoulder.
7. Fasten the both screw bolts and insert 'Feeler gauge' with
reference of below value to each series to secure screw
timing.
Series
Set Filler gauge
value (mm)
8. On the opposite timing gear after insert Feeler gauge,
fasten wrench bolt of the power lock (181) sequentially
with recommended below torque value.
Series
Bolt size
Torque value for
Cap nut (N·m)
See also in detail the installation manual of the power lock
in the 'APPENDIX'.
9. Install the paper gasket (26) to the gasket face of the
gearbox and mount the rear cover assembly over the drive
shaft extension onto the gearbox.
10. Set the cover bolts, drain plug and fill the oil to the oil
reservoir.
The detail instructions of the lubrications are mentioned
on the 'APPENDIX'.
Ver. JRZSM-1807
ZS100 ZS200 ZS300
0.10 0.12
ZS100 ZS200
M6 M6
16.7 16.7
0.15
ZS300
M8
40.2
Fig. 24
Fig. 25
Fig. 26
Fig. 27
15