Printer Problems; The Internal Printer Will Not Print; Display Problems; The Display Does Not Turn On - Midtronics EBT-965P User Manual

EBT-965P
3. Place a new roll of paper in the compartment. The paper feeds from the bottom of the roll.
4. Pull the paper forward so that it extends past the serrated edge of the paper slot.
5. Close the door and make sure the lever locks securely. For a clean tear, pull the paper along
the serrated edge. Do not pull the paper straight out of the printer.

Printer Problems

The internal printer will not print

The analyzer must be connected to the vehicle battery to print to the internal printer. Check
•
the clamp connections to the battery.
The vehicle battery may be too low to power the printer. Connect to a battery with at least
•
11.5 volts.
Verify that the paper is properly installed.
•
Verify that the paper sensor is clean and undamaged.
•

Display Problems

The display does not turn on:

Check the connection to the battery.
•
The analyzer's internal batteries may need to be replaced.
•

The display flickers or is dim:

The contrast may need to be adjusted in the Admin/Utility menu. Highlight the Display icon
•
and press ENTER. Use  or  to scroll the contrast value to 10.
The analyzer's internal batteries may need to be replaced.
•

Internal Batteries

The tester uses six AA, 1.5-volt batteries (alkaline recommended) to allow testing of batteries down
to 1 volt and supply power while the menu is active.
www.midtronicseurope.com
7 – Maintenance & Troubleshooting
23