One-Port 10 Ge Xfp Interface Module - 3Com 4210G Series Getting Started Manual

A dual-port 10 GE XFP interface module provides two 10 Gbps XFP optical ports. You can insert an XFP
transceiver into the port to connect it to another XFP port through an optical fiber. You can select the
following XFP transceivers in
Table 1-17 XFP transceivers supported by 10 GE XFP interface module
Transceiver
XFP-SX-MM850
XFP-LX-SM1310
XFP-LH40-SM1550-F1
You are recommended to use XFP transceivers of 3Com on the Switch 4210G.
The types of XFP transceivers may vary over time. Consult 3Com marketing personnel or technical
support personnel to obtain the latest information about XFP transceivers.

One-port 10 GE XFP Interface Module

Figure 1-18 One-port 10 GE XFP interface module
Figure 1-19 Front panel of one-port 10 GE XFP interface module
This module provides one 10 Gbps XFP optical interface. You can select the following XFP transceivers
as required. A one-port 10 GE XFP interface module provides one 10 Gbps XFP optical port. You can
Table 1-17 as required.
Central
Connector
wavelength
850 nm
LC
1310 nm
1550 nm
1-17
Fiber
50/125 µm multimode
optical fiber
62.5/125 µm
multimode optical fiber
9/125 µm single mode
optical fiber
9/125 µm single mode
optical fiber
Max
transmission
distance
300 m (984.25 ft.)
33 m (108.27 ft.)
10 km (6.21 mi.)
40 km (24.85 mi.)