Allen-Bradley PLC-5 User Manual page 23

keyswitch; selects controller mode
channel 2A status indicator
(lights green and red)
8-pin mini-DIN, DH+ programming
terminal connection parallel to channel
2A when channel 2A is configured for
DH+ communications
channel 2A communication port;
its default configuration is unused
channel 2B communication port;
its default configuration is unused
channel 1A status indicator
(lights green and red)
8-pin mini-DIN, DH+ programming terminal
connection parallel to channel 1A
channel 1A communication port;
its default configuration is DH+
at 57.6 kbps
2
channel 1B communication port;
its default configuration is remote I/O scanner
Install battery here
1
Channel 0 is optically-coupled (provides high electrical noise immunity) and can be used with most RS-422A
equipment as long as:
termination resistors are not used
the distance and transmission rate are reduced to comply with RS-423 requirements
2
Configure these 3-pin ports for:
remote I/O scanner,
remote I/O adapter,
DH+ communication
unused
PLC-5/40, -5/46, -5/60, -5/80, and -5/86 Controller Front Panel
2
2
2
Understanding Your Programmable Controller
battery indicator (red when the battery is low)
controler RUN/FAULT indicator (green when
running; red when faulted)
force indicator (amber when I/O forces are enabled)
channel 0 communication status indicator
(green when the channel is communicating)
channel 2B status indicator (lights green and red)
channel 0-25-pin D-shell serial port; supports standard
EIA RS-232C and RS-423 and is RS-422A compatible
Use this port with ASCII or DF1 full-duplex, half-duplex
master, and half-duplex slave protocols. The port's
default configuration supports processor programming:
DF1 point-to-point
2400 bps
no parity
channel 1B status indicator (lights green and red)
Use these labels to write information about the
channel: communication mode, station addresses etc.
Install memory module here
PLC-5 family member designation
Publication 1785-UM012D-EN-P - July 2005
1-5
1
one stop-bit
BCC error check
no handshaking