Using Your Design Espresso Advanced Plus; Pre-Programmed Shot Volume - 1 Cup - Gastroback DESIGN ESPRESSO ADVANCED PLUS Operating Instructions Manual

Note:
Do not clean any of the parts or accessories in the dishwasher.

USING YOUR DESIGN ESPRESSO ADVANCED PLUS

Filling the Water Tank
• Ensure the water filter is securely fitted inside the tank.
• Fill the water tank with cold tap water to the maximum mark on the side of the tank
and slide the water tank back into position at the back of the machine.
• Plug the power cord into power outlet and switch On at power point.
• Press the POWER button to On. The POWER button surround will flash while the
machine is heating. When the correct temperature has been reached, all the button
surrounds on the control panel will illuminate.
Note:
Check the water level before use and replace the water daily. The water tank should
be filled with fresh, cold tap water before each use. Do not use mineral or distilled
water or any other liquid.
PRE-PROGRAMMED SHOT VOLUME – 1 CUP
64
Press the 1 CUP button once. A preset volume of approximately
30mls will be extracted. The machine will automatically stop once
the preset volume has been extracted.
Note:
The amount of espresso extracted in the cup will vary depending
on your grind size and dose amount.
Tamping the Ground Coffee
Once the grind function has been completed,
carefully withdraw the portafilter from the grin-
ding cradle, being careful not to spill any
ground coffee, tap down to collapse and
using the integrated tamper, tamp down firmly
(approx. 15-20 kg of pressure).