LG-Ericsson IPECS 1000i Series User Manual page 66

1000i Series IP Phone (SMB)
User Guide
2) Check and change the value of Profile Number item on the top.
3) Click the Save button or the Save icon at the top.
4) The confirmation text that the profile number has changed is displayed in the upper left corner. It is
not active yet, and changes to the profile are completed after the restart.
5) Reboot.
To set the phone user-interface configurations:
1) Click one menu item in the Phone Configuration category on the left.
2) In the Phone User-Interface screen, the following attributes may be changed.

Use of Lunar Calendar; When it is enabled in Korean mode, the lunar calendar is displayed on the
LCD calendar. (Supported on 1030i, 1040i and 1050i)

Background Image; 1030i, 1040i and 1050i can use this menu to set the background image of LCD. In
addition to specifying in default pictures, you can also add a new picture from your PC. The size of
user background image should be 320x240 (1030i), 480x320 (1040i) and 480x272 (1050i). The
supported image formats are png and bmp format. (24 bit per pixel format)
i. Press the [Set user background image] button.
ii. Check the optimal size of the picture.
iii. Select the appropriate picture and press the [Upload] button.
iv. Click the Save button or the Save icon at the top.

Label Transparency; The transparency of the label background on IDLE screen. The closer to 100,
the more transparent. It's supported on 1030i, 1040i and 1050i.

Screen Timeout; One of the screensaver features. The screensaver is activated after the timeout has
elapsed since the last action. It's supported on 1030i, 1040i and 1050i.

Screen Saver type; The screen to be shown during the screensaver operation. It's supported on 1030i,
1040i and 1050i.

LCD Password is required to access the Network Setting menu. Please contact your system
administrator for more information, including defaults.
3) Change the value of the desired fields, then click the Save button or the Save icon at the top.
To upgrade firmware:
1) Prepare a valid firmware SW distributed by the manufacture.
Click "Firmware upgrade" in the Phone Configuration category on the left.
2)
Click "Upload File" after choosing a new upgrade file. You cannot cancel the upgrade process after
3)
starting. Do not turn off the power while applying new firmware.
4) At the end of the process, the result of upgrade or a reboot button will appear. Restart completes
applying new firmware.
To set as default:
Click the "Set to default" link on the left.
1)
Or go to the "Phone Status" menu. Find "Load Default Settings" section and click the "OK" button in
2)
that section.
3) Confirm your actions. Restart completes the setup as default.
58
Issue 1.0