FARMSCAN jackal V3.5 Manual page 12

CALIBRATION (MANUAL RATIO)
1. Ensure that the sensor and pickup are end-end before continuing
2. Mark bottom centre of tyre on which the sensor is fitted and mark ground in corresponding position
3. Drive ONE full rotation of the wheel, returning the mark point on tyre to bottom centre
4. Measure between the two points.
o This is your Manual Ratio (Example 1.24m)
Select MANUAL RATIO 1.0
Select EDIT
Press EDIT to change the
input name or
Press NEXT to continue
Press the UP arrow to
highlight the width.
Press EDIT & use the NAV
buttons to change the
implement width. E.g. 12m.
Pressing EDIT will change the
Unit of Measure
Press NEXT.
THIS ENDS THE MANUAL RATIO SET WIZARD SETUP FOR SPEED/AREA METER
AM-JACKAL-B / OCT 2018
Using the NAV buttons enter
your measured distance. i.e.
1.240000
Press EXIT when done.
Select km/h or mph to display
the speed on the front
screen.
Press EXIT & NEXT to finalise
the setup of the Speed &
Area Wizard.
nd
If you have a 2 sensor
connected to Input 1 press
NEXT to continue the wizard.
WWW.FARMSCANAG.COM
Press NEXT
You have the option to set
Alarm Min/Max points if
required. Using the NAV
buttons select and EDIT as
required. Press NEXT
Using the NAV buttons
select how you would like
the area to be displayed on
the front screen. Press NEXT
Press EDIT to change the
input name or
Press NEXT to continue
11