General Description - FARMSCAN jackal V3.5 Manual

GENERAL DESCRIPTION

The Jackal Basic is capable of monitoring 3 functions simultaneously (2 inputs) – e.g. Speed/Area &
Tachometer. Input 1 – RPM Only / Input 2 – Speed/Area Only
The inputs can have both high and low alarm thresholds set which can trigger a visual and audible alarm if
necessary.
The unit employs a large daylight readable LCD to provide legible characters on the display and enable
calibration data to be clear and descriptive.
Our onboard calibration wizard makes setup a breeze! It's simplified with the ability to enter either a factor
(pulses per unit) or simply drive/run a set amount whilst the unit is counting the pulses and let the system
calculate its own factor.
24 recordable trips allows the operator to track numerous jobs in a period of work.
Each input can be used to display information using imperial and metric units.
TECHNICAL SPECIFICATIONS
Specifications below are subject to change and are based on a Jackal with all features unlocked.
Power Requirements
Display
Operating Temperature
Storage Temperature
Dimensions
Sensor Inputs
Inputs 1-5 & 8-9 (Square Wave)
Inputs 6-7
GPS
Ground
Output PWM (Control Version Only)
Output +12v
Output
Output current rating
DISCLAIMER
The warranty offered on this Farmscan Ag product is limited to the repair or replacement of the faulty
goods. No liability will be accepted for loss of profit or productivity.
WARRANTY IS VOID if power and or sensors are not connected as described in this guide.
AM-JACKAL-B / OCT 2018
135mm H x 100mm W x 30mm D
Up to 400 pulses per second (On/Off/Freq)
WWW.FARMSCANAG.COM
1 2 VDC @ 250mA
128 x 64 Mono Graphic LCD
0 to 50˚c
-5 to 65˚c
Analog Voltage 0 – 5V
TX/RX
4A/output
9
2
2
1
4
1