Connections - FARMSCAN jackal V3.5 Manual

CONNECTIONS

The connector on the rear of the Jackal Basic has the following connection points available for use
POWER CONNECTION
Power connection must come direct from the battery terminals. WARRANTY IS VOID if power is not
connected as described in this section.
1. Connect power cable supplied DIRECTLY TO BATTERY
2. Ring terminals are used for battery connection and the bare end used to connect to the rear Jackal.
(Refer above image for power connection)
3. Connect Ground to BATT -VE, Terminal B11 using the
4. Connect
5. Ensure that the battery connection to the Jackal is
AM-JACKAL-B / OCT 2018
+12 Volts (+battery terminal) to BATT +VE, Terminal B10 using the
Connecting 24V to the Jackal will VOID WARRANTY – 12V ONLY
WWW.FARMSCANAG.COM
RED
+12 Volts
Disconnect the terminal plugs
from the Jackal if ARC
WELDING on machinery
with BLACK stripe wire
red wire
3