Commissioning; Unpacking; Checking The Original Dimensions - KERN HFD Series Operating Instruction

5. Commissioning

Attention: Always observe chapter 3 "General Safety Instructions"!
5.1

Unpacking

SAFETY
INSTRUCTIONS
for protection against
break
CAUTION
Danger for the back!
Only use original packaging for returning.

Make sure that all parts are completely present.
• Crane scales
• Mains adapter
• Remote control
• Operating instructions (logbook)
5.2

Checking the original dimensions


Enter the original dimensions shown on the production data sheet in the grey
fields of the checklist chap. 10.3.

Check original dimensions of crane balance; for implementation see chap.10.2
"Regular Maintenance"

Enter all data (date, tester, results) in the first line under "Inspection before first
use" in the checklist (see chapter 10.3)
If the dimensions of your first safety inspection do not match those
of KERN, the balance must not be put into operation. In this case
please contact a service partner authorised by Messrs. KERN.
CAUTION
18
Once delivered and unpacked, crane scales will not be
taken back.
The crane scales have been sealed by Messrs. KERN.

Load suspension devices are sealed by an adhesive
tape.

The packaging is also sealed by adhesive tape.
+
Broken seal obliges to purchase.
Thanks for your comprehension.
Your KERN Quality assurance team
The crane scales are compact and quite heavy.

Remove the scales from packaging only with the help of
a second person.

Use a lifting device such as a crane or a forklift truck.

Secure the scales that they cannot fall down when they
are lifted.
HFD-BA-e-1820