Installation; Installation Of Each Unit - Panasonic S-LINK V User Manual

Basic Procedures

Installation

Installation of each unit

There are 3 unit installation methods.
Considering the installation conditions, select an optimum installation method.
● Installation using screws
● Installation on 35mm width DIN rail
● Installation on board (for SL-VMC1 and SL-VM□ / VMP□ only)
CAUTION
Regarding the ambient conditions, check the following items, and then install each unit:
● Check that the address setting switches, etc. are valid.
● Check that covers can be opened or closed.
● Check that a heat radiation space (10mm or more) can be secured between the unit and the wall.
● Check that indicators are visible.
● Check that cables can be disconnected and reconnected.
● Installation using screws
Install each unit using M4 pan head screws.
For the screw tightening torque, refer to the product specifications (Chapter 4).
● Installation on 35mm width DIN rail
1. Preliminarily attach the DIN rail stopper to the unit.
2. Attach the back of the installed stopper to the 35mm width DIN rail.
3. Press the front of the unit to the rail so that the front of the installed stopper can be attached to the 35mm
width DIN rail.
● Removal from 35mm width DIN rail
Insert a flathead screwdriver into the DIN rail stopper, and then pull out the
stopper until the stopper can be locked.
NOTE Prepare M4 pan head screws and 35mm width DIN rail separately.
● Installation on board (for SL-VMC1 and SL-VM□ / VMP□ only)
Solder pins and terminals at 260°C or less within 10 seconds.
48
DIN rail stopper
35mm width DIN rail
or optional installation piece
35mm width DIN rail
Flathead screwdriver
DIN rail stopper