Omron NX Series Network Connection Manual page 31

10.1.3 Monitoring Process Data Values
This section describes how to check process data after it has been output by the program created
in 10.1.2 Programming. Monitoring is performed by setting in the Watch Tab Page.
Select View - Watch Tab Page .
1
Enter the following variable that was created in 10.1.2 Programming to Name .
2
Variable name: SLC_Power_Supply
s
Select Controller - Online .
3
Select Controller - Synchronize... .
4
The Synchronization dialog box is displayed.
Make sure that the check box of the data
5
to transfer (in the figure on the right,
NX102 ) is selected.
Clear the Do not transfer the following.
(All items are not transferred.) check
box, and click Transfer to Controller .
Note: When Transfer to Controller is
executed, Sysmac Studio data is
transferred to the controller and
data is synchronized.
The dialog box on the right is displayed.
6
Confirm that there are no problems, and
click Yes .
The dialog box on the right is displayed.
Confirm that there are no problems, and
click Yes .
The synchronization in progress window
is displayed.
The dialog box on the right is displayed.
Confirm that there are no problems, and
click OK .
Note: Do not return the mode to Run
Mode... .
10 Programming Using IO-Link
28