Advertisement
REVISION HISTORY
Revision
Date
th
1.0
16
November 2012
th
1.1
7
May 2013
th
2.0
30
September 2013
2.1
22
nd
November 2013
2.2
14
th
January 2014
2.3
6
th
May 2014
th
2.4
10
July 2014
th
2.5
30
July 2014
2.6
29
th
May 2015
th
2.7
29
October 2015
th
3.0
26
January 2016
All rights reserved. All information contained in this manual is proprietary and confidential material of SECO S.r.l.
Unauthorised use, duplication, modification or disclosure of the information to a third-party by any means without prior consent of SECO S.r.l. is prohibited.
Every effort has been made to ensure the accuracy of this manual. However, SECO S.r.l. accepts no responsibility for any inaccuracies, errors or omissions herein.
SECO S.r.l. reserves the right to change precise specifications without prior notice to supply the best product possible.
For further information on this module or other SECO products, but also to get the required assistance for any and possible issues, please contact us using the
dedicated web form available at
http://www.seco.com
Our team is ready to assist you.
Q7-928
Q7-928 User Manual - Rev. First Edition: 1.0 - Last Edition: 3.0 - Author: S.B. - Reviewed by P.Z Copyright © 2016 SECO S.r.l.
Note
First Release
Introduction and Technical features revised; Block Diagram updated
®
Power consumption added; Qseven
New manual release
Minor corrections; Technical features updated: number of independent displays and LVDS max resolutions
updated; Supported Operating Systems added. Limitation about PCI express support added. Pull-up
resistors indicated on signals UART0_RX and UART0_CTS#.
Corrected pull-up to pull-down on WDOUT signal description
LVDS resolution combinations corrected (par. 3.2.3.8)
μSD card slot warning added (par 3.2.2); LVDS resolution combinations corrected (par. 3.2.3.8); SUS_S4#
signal name changed to SUS_S5#
SDIO_PWR Signal added in Qseven golden card edge connector's pinout
Minor corrections about signal names in paragraph 3.2.3.15
Added I2C table in par. 3.2.3.14
Heatspreader and heatsink description updated in par. 4.1
®
Qseven
connector's pins 125, 127 description corrected
UART0_RTS# and UART0_CTS# signals removed from Qseven
3.2.3.2 updated consequently
Product Name change
(registration required).
golden finger pinout updated
®
connector's pins 172, 178. Paragraph
Rif
SB
SB
SB
SB
SB
SB
SB
SB
SB
SB
SB
2
Advertisement
