ResMed Quattro FX User Manual page 11

Reassembly
Refer to the reassembly illustrations in this guide.
Reassembly Steps
1. Insert the valve into the clip.
2. Push the valve clip onto the elbow and insert the swivel into the end
of the elbow.
3. Replace the ports cap.
4. Fit the cushion into the channel of the frame. Fit the top section fi rst,
then work your way around, pushing the cushion into the frame.
Ensure that the cushion is not twisted or distorted around the frame.
5. Replace the soft sleeves onto the spring frame and align the spring
frame with the frame.
6. Starting at the top, gently push and click the spring frame into the
frame.
7 . Gently push and click each side of the lower spring frame into the
frame.
8. Replace the elbow into the mask assembly.
Cleaning your mask in the home
Your mask and headgear should only be gently handwashed.
Daily/After each use:
• Disassemble the mask components according to the disassembly
instructions.
• Thoroughly clean the separated mask components (excluding headgear),
by gently rubbing in warm (approximately 30°C) water using mild soap.
• To optimise the mask seal, facial oils should be removed from the cushion
after use.
• Use a soft bristle brush to clean the vent.
• Inspect each component and if required, repeat washing until visually
clean.
• Rinse all components well with drinking quality water and allow to air dry
out of direct sunlight.
• When all components are dry, reassemble according to the reassembly
instructions.
Weekly:
• Handwash the headgear. It may be washed without being disassembled.
• Handwash the soft sleeves.
4