Kramer VS-88UT Quick Start Manual page 4

Step 6: Operate via the Web pages:
Route video and audio signals:
Click a white button in the matrix to route an input to an output (audio and/or video).
Optional input to output routing.
Current input to output routing state.
Additional functions:
Inputs: HDMI and HDBT
Analog Audio
Outputs: HDMI and HDBT
Analog and Amplified Audio:
Default communication parameters:
RS-232
Protocol 3000
Baud Rate:
Data Bits:
Example (Set the volume on analog audio input 5 to 10dB):
TCP/IP Parameters
IP Address:
Subnet mask:
Default gateway:
TCP Port #:
Full Factory Reset
Use "#FACTORY" command
Protocol 3000
Video only is routed.
Audio only is routed.
Click the input name to change its settings.
Click to route the audio and video inputs separately.
Click to toggle between the HDBT and HDMI input.
Click the input name to change its settings.
Click to change audio level settings.
Click to toggle between one analog input signal and two mic. Input signals.
Click the output name to change its settings.
Audio-only mode is enabled/disabled.
/
Audio-follow-video mode is enabled/disabled.
/
/
Pattern is selected/not selected.
Click to change audio settings.
115,200
8
192.168.1.39 UDP Port #:
255.255.000.000 Maximum UDP Connections:
192.168.0.1 Maximum TCP Connections:
5000
and use "
#RESET
An active signal is detected (for inputs and outputs).
No active signal is detected (for inputs and outputs).
Stop Bits: 1
Parity: None
#X-AUD-LVL IN.ANALOG_AUDIO.5.AUDIO.1,10
50000
Unlimited
Unlimited
" to restore the factory default values.
HDMI is on/off.
/
AUDIO is on/off.
/