Kramer VS-88UT Quick Start Manual page 3

Step 3: Install the VS-88UT
To rack mount the machine attach both ear brackets to the machine (by removing the five screws
from each side of the machine and replacing those screws through the ear brackets) or place the
machine on a table.
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your VS-88UT. For best results, we recommend that you
always use Kramer high-performance cables to connect AV equipment to the VS-88UT.
RJ-45 pinout:
For the Ethernet and HDBaseT connectors, see the proper wiring
diagram below
Step 5: Connect the power
Connect AC power to the rear of the VS-88UT, switch on its power and then switch on the power on each device.
Safety Instructions
Caution: There are no operator serviceable parts inside the unit.
Warning: Use only the power cord that is supplied with the unit.
Warning: Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
Warning: Disconnect the power and unplug the unit from the wall before installing.
See www.KramerAV.com
PIN EIA /TIA 568B
PIN Wire Color
1 Orange / White
2 Orange
3 Green / White
4 Blue
5 Blue / White
6 Green
7 Brown / White
8 Brown
for updated safety information.
Connect the audio input:
To a balanced stereo audio
source:
Connect the audio output:
To a balanced stereo audio
acceptor
To an unbalanced stereo audio
source:
To an unbalanced stereo audio
acceptor