Digital Projection POWER 2v User Manual page 11

LBV00018; Revision E - 28/01/98
Packaging
Projector Packaging
To provide protection during transportation, the projector is surrounded with foam,
placed on a wooden palette and enclosed within a sturdy fibreboard carton. The
package is then secured with banding and fastening clips.
To unpack the projector, first release the two fastening clips and remove the
banding. Next, using the finger holes provided, gently lift off the outer cover of the
carton. Do not open the tape seal on the top of the cover.
Lift out the carton containing the peripheral equipment and place to one side, then
remove the two sections of protective foam.
Due to the projector's weight, four people are required to lift the projector, one at
each corner using the finger grips on the underside. The purchaser is reminded to
use good practice in lifting the projector to avoid risk of back injury.
All packaging should be retained to provide maximum protection during future
shipping of the projector. To repack the projector, reverse the above procedure.
Contained within the packaging will be:
1 x POWER display Projector
1 x AC Power Cable
4 x Projector Mounting Feet
Should any of the above components be absent, please contact the dealer who
supplied the projector, or Digital Projection Limited (Digital Projection Inc. if in
North America) immediately.
Lens Packaging
Lenses are supplied as individual items and the packaging may differ depending on
the version ordered. Please refer to the instructions supplied with your lens.
1 x Remote Control Unit
1 x User Manual
Overview
AÑ1