LEGRAND ELIOT Kit STOP&GO Connected Manual page 5

ELIOT Kit STOP&GO Connected
4. PREPARATION - CONNECTION
Diagnostic procedure
(continued)
5. Test 1/3 - Set the AUTO/MAN selector to "MAN" (the Stop&Go
LED flashes slowly in green)
Once the test is complete, press "Next" to proceed to the next test.
6. Test 2/3 - Set the AUTO/MAN selector to "AUTO" (the Stop&Go
led is steady green)
Once the test is complete, press "Next" to proceed to the next test.
7. Test 3/3 - Simulation of a non-permanent fault and a remote
reclosing
7.1 Press the "TEST" button of the protection device associated to
the Stop&Go (the Stop&Go power handle is down, and the
isolating handle is up and the Stop&Go led flashes quickly in red)
7.2 An alert message is displayed
7.3 Press on "TURN ON"
Technical data sheet: F02465EN/01
(continued)
:
Updated: 28/03/2019
Cat. N°: 4 149 54
4. PREPARATION - CONNECTION
Diagnostic procedure
(continued)
7. Test 3/3 - Simulation of a non-permanent fault and a remote
reclosing
(continued)
7.4 Press "OK" to confirm the reclosing (the two Stop&Go handles
are upward and the Stop&Go led goes steady green)
Once the test is complete, press "Finish".
Note:
a. It is always possible to repeat the procedure by pressing "Restart
test"
b. If one or more tests fail:
- check the connection between the Stop&Go and the Wi-Fi
interface
- Repeat the test procedure
Created: 06/10/2016
(continued)
:
5/16