Related Manuals for LEGRAND Céliane 670 85
Summary of Contents for LEGRAND Céliane 670 85
- Page 1 www.lum-art.ru Céliane Universal dimmer switch 670 85 Description Setting of minimum and maximum thres- holds for compact fluorescent loads Product configuration micro-switch: - Default setting - Description page 5...
- Page 2 www.lum-art.ru Characteristics 35°C ( * ) 0°C Dimmable dimmable 100 V AC 2 x 2.5 mm 240 V AC 50/60 Hz Max. 300 W 300 W 300 VA 300 VA 160 VA 160 VA 160 VA 160 VA 160 VA 240 V AC Min.
- Page 3 www.lum-art.ru Wiring...
-
Page 4: Installation
www.lum-art.ru Installation * not supplied with the mechanism... - Page 5 www.lum-art.ru Configuration Reserved for “After-sales Service” Product configuration (see detail § “End stop setting method” for type lamps. Level memory activated deactivated Selection of the type of load...
- Page 6 www.lum-art.ru Configuration (cont.) Capacitive mode (**) Not dimmable (**) According to the lamp manufacturer.
-
Page 7: Inductive Mode
www.lum-art.ru Configuration (cont.) Inductive mode (**) ( * ) Dimmable (*) Use only with transformers designed to function with elec- tronic switches. (**) According to the lamp ma- nufacturer. Lamps of different types must not be mixed in the same product. When changing lamp type, start by placing the product in factory configuration by positioning the micro-switches as follows:... - Page 8 www.lum-art.ru Configuration (cont.) Fluorescent and compact fluorescent lamps: Minimum and maximum lighting settings, recommended when the lamp flickers. (Before setting, let the lighting stabilise by leaving the lamp lit for a few seconds). Set the minimum level Set the maximum level of lighting sought of lighting sought The right-hand buttons (+/-) can now be used to vary the level in the dimming range set using two potentio-...
- Page 9 www.lum-art.ru Configuration (cont.) When first switching on, if the load starts blinking then remains out: 1 - Check that the green and orange LEDs blink in succession. 2 - Reverse the position of switch 1. 3 - The LEDs stop blinking. 4 - The equipment is therefore working correctly.
- Page 10 Do not open up, dismantle, alter or modify the device except where specifically required to do so by the instructions. All Le- grand products must be opened and repaired exclusively by personnel trained and approved by Legrand. Any unauthorised opening or repair completely cancels all liabilities and the rights to replacement and guarantees.