Table of Contents
Advertisement
ELIOT Kit STOP&GO Connected
9. APPLICATION MESSAGES
. Hereunder are listed messages displayed by the Smartphone app, their meaning and possible actions to be done by the user
1.
Associated device is "OFF" and Stop& Go in AUTO mode.
2.
A non-permanent fault occurred
3.
Stop&Go has been open manually
4.
A "too recurrent" non-permanent fault has been detected
Stop&Go detects a permanent fault after an OFF remote operation
5.
or a tripping of the associated device
6
Stop&Go is in MAN mode
Technical data sheet: F02465EN/01
Cat. N°: 4 149 54
Remote reclosing command (closing of the circuit) allowed
Remote reclosing command (closing of the circuit) allowed
Remote reclosing command (closing of the circuit) not-allowed
Close manually the Stop&Go
Remote reclosing command (closing of the circuit) not-allowed
Contact your electrician to check your installation
Remote reclosing command (closing of the circuit) not-allowed
Contact your electrician to check your installation
Remote reclosing command (closing of the circuit) not-allowed
Put selector in "AUTO" position
Updated: 28/03/2019
Created: 06/10/2016
Remote co
15/16
Advertisement
Table of Contents
