General Characteristics - LEGRAND ELIOT Kit STOP&GO Connected Manual

ELIOT Kit STOP&GO Connected
4. PREPARATION - CONNECTION
Wi-Fi module signalling led
. Wi-Fi led: indicates the status of the Wi-Fi Network:
Possible states:
State
Led colour
Slow blinking
Fast blinking
(pressing the
multifunction button
red
longer than 30 sec.)
Steady
Slow blinking
Fast blinking
green
Steady
Slow blinking
Fast blinking
orange
Steady
Wi-Fi module front face button:
. It is used to put the Wi-Fi interface in programming mode or to
restore factory settings:
Possible states:
Pressing time
Wi-Fi interface put in configuration mode via
t ≈ 3 sec.
WPS button
Wi-Fi interface put in configuration mode via
t ≈ 7 sec.
"Manual procedure"
Wi-Fi interface total reset
t > 30 sec.
[any firmware updates are preserved]
Technical data sheet: F02465EN/01
(continued)
(continued):
Meaning
No Wi-Fi- network detected or
connection problems
Total reset
[any firmware updates are
preserved]
Wi-Fi signal ≤ 25%
Scanning for Wi-Fi network
(during association procedure)
Programming via WPS button
of the Wi-Fi router
Wi-Fi signal ≥ 50%
Interface not associated to any
network
(Factory configuration)
Manual Programming mode
Wi-Fi signal between 25% and
50%
Action
Updated: 28/03/2019
Cat. N°: 4 149 54
4. PREPARATION - CONNECTION
Power supply module signalling led:
. Indicates the status of operation of the supplier:
- Steady green → system OK
- Steady off → supplier malfunctioning
Labelling:
. Circuit identification by way of a label inserted in the label holder
situated on the front of the Stop&Go and of the Power supplier.

5. GENERAL CHARACTERISTICS

Stop&Go marking:
. Front side marking: by permanent pad printing
Red arrow to indicate that the front face of
the device can be put down
Terminals marking:
. Upstream terminal-block: by permanent ink pad printing.
. Downstream terminal-block: by permanent ink pad printing.
Created: 06/10/2016
(continued):
"ELIOT product" symbol
AUTO/MAN Selector
8/16