Emerson Bettis Q Series Reference Manual page 35

Reference manual F
DOC.RM.BQC54.E Rev: 1
February, 2016
Table 4.3 Bettis Q-Series™ Alerts & recommended actions
Alerts
Parameter name
bad_position_sensor
bad_temperature_sensor
system_temperature_exceeded
software_error
travel_deviation
shutdown_is_set
pilot valve_error
Buttonboard_error
cm_life_exceeded
pm_life_exceeded
act_life_exceeded
valve_life_exceeded
time_in_position_exceeded
open_travel_time_exceeded
close_travel_time_exceeded
assembly_error
initialization_failed
Fieldbus Control module
OUNDATION
DeltaV text Recommended actions
Position Sensor Error Feedback problem, replace Control module when
possible
Temperature Sensor Temperature sensor problem, replace Control
Error module when possible
System Temperature Take corrective actions to bring temperature
Exceeded within specified range.
Software Error Software error has been detected, replace
control module when possible.
Travel Deviation Lost position, Check air pressure
Shutdown Is Set Internal communications problem, check
shutdown configuration for restart, Replace
Control module.
Pilot valve error Pilot valve number mismatch or pilot valve failure
has been detected
Buttonboard Error Replace control module when possible
Control Module Life Control module life cycle exceeded, replace
Cycle Exceeded control module
Pneumatic Module Life Pneumatic module life cycle exceeded, replace
Cycle Exceeded pneumatic module.
Actuator Life Cycle Actuator life cycle exceeded, replace actuator.
Exceeded
Valve Life Cycle Valve life cycle exceeded,valve requires
Exceeded maintenance.
Time in position Time in position exceeded, take appropriate
exceeded action.
Open travel timer Open travel timer exceeded, check valve system.
exceeded
Close travel timer Close travel timer exceeded, check valve system.
exceeded
Assembly error Pneumatic function mismatch, check module and
actuator configuration
Initialization Failure Device failed initialization; Check air pressure,
check actuator sizing, check valve system
Internal alerts
Counter alerts
Timer alerts
Initialization alert
Alert default setting
Advisory Maintenance
n n y y
n n y y
n n y y
n n n n
n n n n
n n n n
n n y y
n n y y
n n n n
n n n n
n n n n
n n n n
n n n n
n n n n
n n n n
n n n n
n n n n
Fail
n n
n n
n n
y y
y y
y y
n n
n n
n n
n n
n n
n n
n n
n n
n n
y y
n n
Page 35