Emerson Bettis Q Series Reference Manual page 31

Reference manual F
DOC.RM.BQC54.E Rev: 1
February, 2016
Table 4.2 Bettis Q-Series™ Transducer Block (continued)
Index Name
No.
11 XD_ERROR
12 COLLECTION_DIRECTORY A directory that specifies the number, starting indices, and DD Item IDs
13 FINAL_VALUE_D
14 ACT_FAIL_ACTION
15 ACT_MAN_ID
16 ACT_MODEL_NUM
17 ACT_SN
18 VALVE_MAN_ID
19 VALVE_MODEL_NUM
20 VALVE_SN
21 VALVE_TYPE
22 XD_CAL_LOC
23 XD_CAL_DATE
24 XD_CAL_WHO
25 DISCRETE_POSITION
26 OPEN_STATE
27 CLOSE_STATE
Fieldbus Control module
OUNDATION
Description
General Transducer Block parameters (continued)
Extensions to Block Error indicated by the "Other" bit 0 being set
(enumeration)
16: Unspecified error
17: General error (not used)
18: Calibration error
19: Configuration error (not used)
20: Electronics failure
of the data collections in each transducer within a Transducer Block.
States the requested valve position and status written by a discrete
function block (set point)
STATUS
VALUE requested position 0: close, 1: open
Defined by Foundation Fieldbus, has no effect on our device!
0: undefined (DA), 1 Self-closing(SA), 2 Self opening(SA)
Actuator manufacturer ID in Foundation Mfg id units.
Is: Emerson Process Management Valve Automation Division
Actuator model number. Depends where it is mounted.
Can be set by customer.
Serial number of actuator.
Can be set by customer.
Valve manufacturer ID in Foundation Mfg id units.
Can be set by customer.
Indicates available function block execution routines
Serial number of valve.
Can be set by customer.
Type of valve. Can be set by customer, but it is not used by the device.
0: undefined, 1: Sliding stem, 2: Rotary
The location where device was last initialized.
Can be set by customer,
The date the unit was calibrated/initialized.
Can be set by customer.
Person who did the calibration.
Can be set by customer.
Device position status parameters
Single signal indicating the current discrete position
STATUS
VALUE
0 = closed,
1 = opened,
2 = Closing (based on not being 0 or 1 and the current position request)
3 = opening (based on not being 0 or 1 and the current position
request)
Discrete position feedback
0: false, 1: true
STATUS (bad when loose IO board comms block err, uncertain sensor
error)
VALUE
0 false, 1: true
Discrete position feedback
0: false, 1: true
STATUS (bad when loose IO board comms - block err, uncertain when
sensor bad)
VALUE
0 false, 1: true
21: Mechanical failure (not used)
22: I/O Failure
23: Data Integrity error (not used)
24: Software error
25: Algorithm error (not used)
Valid Range Initial Value Permission
0 = no error 0 = no error Read only
0 0 Read only
2 Read only
Read only
0 to 1 0 Read only
0 to 3 0 Read / Write
0x564144 0x564144 Read only
All spaces Read / Write
All spaces Read / Write
0 Read / Write
All spaces Read / Write
All spaces Read / Write
0 to 2 2 Read / Write
All spaces Read / Write
Read / Write
All spaces Read / Write
Read only
0 to 3 0 Read only
true/false FALSE
Read only
0 to 1 0 Read only
true/false FALSE
Read only
0 to 1 0 Read only
Page 31