Emerson Bettis Q Series Reference Manual page 30

Table 4.2 Bettis Q-Series™ Transducer Block
Index Name
No.
1 ST_REV
2 TAG_DESC
3 STRATEGY
4 ALERT_KEY
5 MODE_BLK
6 BLOCK_ERR
7 UPDATE_EVT
8 BLOCK_ALM
9 TRANSDUCER_DIRECTORY Array containing the transducer definitions (empty)
10 TRANSDUCER_TYPE
Page 30
Reference manual F
Description
General Transducer Block parameters
Static data revision. Updated when static data is changed
Unique description for the transducer block within a system, writable by
the host system operator.
Used by host system administrator to group blocks for easy
identification of location.
Plant unit ID, for host system operator for sorting alarms
The target, actual and permitted modes for the block
TARGET
ACTUAL
PERMITTED
NORMAL
Error status associated with the hardware or software of the resource
block (enumeration)
0: Other
1: Block config error (not used)
2: Link configuration error
3: Simulate Active: Based on switch
4: Local override (not used)
5: Device Fail safe set
6: Device needs Maintenance Soon
7: Input failure (not used)
8: Output failure (not used)
Alert generated by a change to static data.
UNACKNOWLEDGED:
0 undefined, 1 acknowledged, 2 unacknowledged
ALARM_STATE
0:Undefined 0
1:Clear- Reported
2:Clear- Not reported
3:Active- Reported
4:Active- Not reported
TIME_STAMP
SUB_CODE
RELATIVE INDEX
The block alarm is used for all configurations, hardware connection
failures and system problems in the block. The cause of the alert is
entered in the sub-code.
UNACKNOWLEDGED:
0 undefined, 1 acknowledged, 2 unacknowledged
ALARM_STATE
0:Undefined 0
1:Clear- Reported
2:Clear- Not reported
3:Active- Reported
4:Active- Not reported
TIME_STAMP
SUB_CODE The alarm is stated here(only Device fail -safe set and
OOS)
VALUE- A value can be added by the customer for configuring alarms
Identifies the type of Transducer Block.
OUNDATION
Valid Range
0 to 65535
7 bit ASCII
1 to 255
7: OOS, 3:
AUTO
0 to 15
9: Memory Failure (FF card)
10: Lost static data (FF card)
11: Lost NV data (FF card)
12: Read back check failed (not
used)
13: Device needs Maintenance
Now
14: Power-up (not used)
15: Out-of-Service
0 to 2
0 to 4
Time
0,0
Standard
discrete
positioner
Fieldbus Control module
DOC.RM.BQC54.E Rev: 1
February, 2016
Initial Value Permission
0 Read only
Spaces Read / write
0 Read / write
0 Read / write
OOS Read / write
N/A Read Only
ALL Read / write
AUTO Read / write
N/A Read Only
Read only
Read / Write
Read only
Read only
Read only
Read only
0,0 Read only
Standard Read only
discrete
positioner