Emerson Bettis Q Series Reference Manual page 10

WARNING:
* Do not put the Control module in direct contact with mag-
netic material. This can cause damage or malfunction of
the position feedback.
* If the Control Module is used in a manner not specified by
the manufacturer, the protection provided by the equip-
ment may be impaired.
* If required, mount earth wire (1) between top (2) and bot-
tom (3) ring of earth wire connection (see figure 2.6).
2.6.5 Procedure
1 Remove control module cover (see figure 2.7)
2 Guide the cable(s) through the electrical entry(ies).
- Use and mount cable glands as required by nation-
al or local legislation.
- When IP66/NEMA4X ingress protection is re-
quired, the electrical entries must be fitted with
glands rated IP66/NEMA4X or higher.
3 Connect the F
oundation
applicable terminals (see figure 2.7).
- For 7/8" or M12 quick connector pinout, see fig
2.9.
- For hazardous area connections, see the con-
trol drawings as indicated in chapter 2.6.2.
4 Mount the control module cover to the hous-
ing (see figure 2.7) or continue with chapter 3.
Take care that the cover seal is in place to com-
ply to dust and water tightness according IP66 /
NEMA4X.
2.6.6 F Fieldbus™ installation
oundation
and wiring guidelines
For various application guides like installation and
wiring guidelines please check:
www.fieldbus.org/About/FoundationTech/Resources/
Fig. 2.6 Earth wire connections
Page 10
Reference manual F
Fieldbus™ signal to the
Fieldbus Control module
OUNDATION
Terminal Control Module
compartment Type Label
Lockable
Module cover
Electrical
entries:
3/4"NPT
or M20
1/2"NPT
or M20
Wiring Terminals
Fig. 2.7 Installing wiring
Field wiring
FF
Power
supply
Fig. 2.8 Terminal and quick connector connections
Quick connector pinouts:
(male chassis part)
1 3
4
3
1
2 4
2
7/8" UNC M12
Fig. 2.9 Quick connector pinouts
DOC.RM.BQC54.E Rev: 1
February, 2016
Button board
Actuator wiring
+
1
2
-
3
Quick connector Terminal
Blue
1
2
4
Brown
2
1
Green/Yellow
3