Polaris 2881529 Installation Instructions page 2

IMPORTANT
Your Tire Mount Kit is exclusively designed for your vehicle. Please read the installation instructions thoroughly
before beginning. Installation is easier if the vehicle is clean and free of debris. For your safety, and to ensure a
satisfactory installation, perform all installation steps correctly in the sequence shown.
ASSEMBLY TIME
Approximately 5–10 minutes
INSTALLATION INSTRUCTIONS
1. Shift vehicle transmission into "PARK". Turn key to
"OFF" position and remove from vehicle.
2. Install two bumpers
shown.
3. Install two LOCK & RIDE
q
to mount frame per anchor kit instructions
EXCEPT as follows: Insert washer
lever and frame as shown.
4. Ensure all expansion anchors
then install mount frame
are fully seated as shown. Depress levers to lock
in place.
If installation is loose, remove frame from bed,
tighten nut at base of affected anchor(s), and
reinstall.
e q
to mount frame as
® expansion anchors
t
between
r
are unlocked,
q
into bed until anchors
Instr 9927735
Install on LH side of bed for front or rear wheel/tire
mounting; RH side installation only permits front
r
5. Install spare tire/wheel (sold separately) to mount
q
frame using handle
mounting hole options are provided: use hole
which allows tire to rest on vehicle bed.
A
Cone can be reversed as shown to accommodate
different wheel configurations and/or orientation.
Handle also functions as lug wrench (two sizes).
Rev 01 2016-05 Page 2 of 2
NOTE
wheel/tire mounting.
w
as shown. Three
NOTE
TIP