Vmac UNDERHOOD 70 Installation Manual page 52

Analog Throttle Control:
With the brake pedal firmly depressed, shift the truck into "REVERSE".
☐
*The engine speed reduces to OEM base idle (Approximately 650 rpm).
☐
*The green LED on the control box remains illuminated.
☐
Repeat these steps in all gear selector positions to ensure the engine speed
does not increase unless the gear selector is in "PARK" or "NEUTRAL".
Digital Throttle Control:
With the brake pedal firmly depressed, shift the truck into "REVERSE".
☐
*The engine speed reduces to OEM base idle (Approximately 650 rpm).
☐
*The green LED on the control box remains illuminated.
☐
*The "STATUS" and "PRNDL" LED's on the digital throttle control will turn off
and engine speed will reduce to base idle.
☐
*Shift the vehicle back into "PARK".
☐
*Cycle the compressor off, then on again to reset the safety parameters.
☐
Repeat these steps in all gear selector positions to ensure the engine speed
does not increase unless the gear selector is in "PARK" or "NEUTRAL".
☐
Allow the compressor to run until the system reaches full system pressure.
☐
Confirm all air valves are closed and the system has no air leaks.
☐
Turn off the compressor.
☐
Ensure any stored air is drained from the system.
Final Testing
Ensure the following has been completed:
☐
Operate the system with an air tool (or the VMAC Air Test Tool with the
appropriate orifice installed) for at least 1/2 hour (1 hour preferred).
☐
Road test the vehicle for approximately 14 miles (20 km).
☐
Observe the compressor operation to ensure that the belt alignment is good
and nothing is rubbing or contacting hot components.
☐
Check all components, connections and fasteners once the engine is turned off
and the system has cooled.
☐
Check the coolant level after the engine has been operated.
☐
Check the compressor oil level after the engine has been shut down and the oil
level has had time to stabilize.
50
VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: www.kb.vmacair.com