☐
Using the retained spring clamp, install the modified coolant drain back hose
onto the degas bottle (Figure 19).
☐
Using the remaining spring clamp, install the hose barb onto the modified
coolant drain back hose (Figure 20).
☐
Using one of the supplied gear clamps, connect the supplied heater hose to the
hose barb on the coolant drain back hose.
☐
Route the hose down toward the VMAC oil cooler, securing it as necessary with
rubber coated P-clips or cable ties.
☐
Using one of the supplied gear clamps, connect the heater hose to the barb on
the oil cooler.
☐
Fill the coolant system with the coolant that was retained earlier.
18
Figure 19 — Install coolant drain back hose
Figure 20 — Install hose barb
VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: www.kb.vmacair.com