Vmac UNDERHOOD 70 Installation Manual page 26

☐
Thread the supplied stud into the extension post, leaving 3 1/2 in of the stud
exposed (Figure 29).
☐
Insert the roll pin into the extension post, followed by the idler fastener retained
earlier. Thread the idler fastener in until it locks against the roll pin (Figure 30).
☐
Install the stud into the engine, below the power steering pulley, and torque it
to 21 ft•lb (Figure 31).
24
Figure 29 — Install extension post
Figure 30 — Install extension post
Figure 31 — Install extension post
VMAC - Vehicle Mounted Air Compressors
VMAC Knowledge Base: www.kb.vmacair.com
3 1/2 in
VMAC Technical Support: 888-241-2289