Vmac UNDERHOOD 70 Installation Manual page 46

☐
Locate the violet wire with white stripe running to pin 30 of the X1 connector
(Figure 55).
☐
Splice the red wire from the VMAC 4 pin interface connector to the violet wire
with white stripe.
☐
Cover the soldered wire with 1/4 in loom, insert the wires back into the OEM loom
and secure with a cable tie.
☐
Reinsert the X1 connector into the junction block.
☐
Unplug the connector from the park brake switch and connect the black wire with
the piggyback connector from the interface cable to the connector on the park
brake switch.
☐
Connect the OEM park brake connector to the piggyback connector.
☐
Reinstall the junction block.
Key switched power is supplied via fuse 30DL in the "instrument
panel left" fuse panel.
44
Figure 55 — Remove PDC
(as viewed from mating side)
VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: www.kb.vmacair.com
Pin 30