Vmac UNDERHOOD 70 Installation Manual page 35

☐
Apply split loom to the 3/16 in and 1/4 in PTFE tubes.
☐
Connect the PTFE tubes to the push-to-connect fittings on the compressor.
☐
Route the PTFE tubes along the 3/4 in discharge hose to the frame rail.
☐
From the 3/4 in discharge hose, route the PTFE tubes along the OEM fuel lines
to the fuel filter.
☐
From the fuel filter, route the PTFE tubes along the top of the AOST, and
connect them to the push-to-connect fittings in the blowdown cap.
☐
Connect the 90° fitting on the shorter 1/2 in hose to the passenger side fitting
on the VMAC oil cooler.
☐
Route the 1/2 in hose to the driver side of the vehicle, then up toward the OEM
wiring bundles (Figure 44).
Figure 44 — Connect compressor oil supply hose
☐
From the OEM wire bundles, route the 1/2 in hose up to the compressor and
connect it to appropriate fitting (Figure 45).
Figure 45 — Connect compressor oil supply hose
VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: www.kb.vmacair.com
33