Atlona AT-HD-SC-500 Quick Start Manual page 5

Dual hdmi and vga switcher w/ scaler and display control

Hide thumbs Also See for AT-HD-SC-500:

Category Cable and Connector

For the category cables used in the installation of these products, please be sure to use a 568B

termination as pictured below:

Important! 4K

(UHD)

use CAT6a/7 solid core cables for best results.

Connector type and size is very important to ensure extenders work correctly. Please use the

matching cable type with the correct RJ45 connector.

Ethernet

For convenience, the HD-SC-500 comes with DHCP on. This enables the switcher to be

connected to a network without knowing available IP addresses. If your network does not allow

dynamic IP addresses or if you are using the switcher with a TCP/IP control system, this feature may

be turned off and the IP address set using front panel.

Note: Press and hold the Input button, on the front panel, for 15 seconds to switch between static and DHCP

mode. The Display button will flash. Two button flashes means the unit is in static mode and four button

flashes means the unit is DHCP mode. Static IP configuration will be: 192.168.1.254 - 255.255.255.0

atlona.com

signals are sensitive to cable quality and installation technique. It is recommended to

(e.g. CAT 7 cable should use a CAT 7 connector)

Toll free: 1-877-536-3976

Local: 1-408-962-0515

Table of Contents