Advertisement
Mounting
The HD-SC-500 comes with mounting brackets that can be used to affix the unit to a table, desk,
etc.
Larger oval
hole will be
attached to
the wall/table.
Mounting bracket x 2
To affix the mounting brackets to the unit, use the four included screws. The bracket can be
affixed with the oval holes pointing to the bottom
facing the top
(for under tables - picture B)
A
Captive Screw
The captive screw connectors allow you to cut cables to a suitable length, reducing cable clutter
while providing a more reliable connection.
Connecting
When connecting the cables to the female captive screw connector it is important that the wires be
terminated correctly. The female captive screw connector has a contact plate at the top and must
have the wires touching it for signal to pass. When wired correctly
incorrectly
(see picture B)
A
B
atlona.com
.
no signal will pass.
The captive screw connectors have
a contact bar that is adjusted to
compress the wire against the top
contact plate. Use the screws at the
top of the connector to compress
the wire against the contact plate.
Circular holes
will always be
attached to the
unit.
(for against the wall - picture A)
B
(see picture A)
Clockwise
Turn the screws clockwise to
raise the contact bar to the
upper contact plate and hold
the wires in place.
3
or the oval holes
the signal will pass,
Counter
Clockwise
Turn the screws counter
clockwise to lower the
contact bar to release the
wires.
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Advertisement
