1.1 PURPOSE OF THIS DOCUMENT
This document describes how to install and put into service the DECT service on an IP network
associated with the following PBXs:
•
NeXspan S/L/D (F6)
•
NeXspan 50 and NeXspan 500 (F4)
•
NCS (F5)
1.2 SCOPE
The IP DECT is applicable as of release 4.2 for the following PBXs:
•
NeXspan S/L/D (F6)
•
NeXspan 50 and NeXspan 500 (F4)
•
NCS (F5)
1.3 AUDIENCE
This document is meant for installers whose tasks are to:
♦
Carry out a study into positioning base stations, and system traffic flow
♦
Connect base stations
♦
Start up the IP DECT system and put it into service.
1.4 REFERENCE DOCUMENTS
/1/
RFC 1350, The TFTP Protocol, Revision 2, July 1992
/2/
OpenMobility Generic Mobility Interface; KI: CTB005933
/3/
OpenMobility Matra Startup; KI: CTB006317
/4/
RFC 1156, Management Information Base for Network Management of TCP/IP-based internet,
May 1990
/5/
RFC 1213, Management Information Base for Network Management of TCP/IP-based internet:
MIB-II, March 1991
/6/
RFC 1450, Management Information Base for version 2 of the Simple Network Management
Protocol (SNMPv2), April 1993
/7/
http://www.simpleweb.org/ietf/mibs/index.html?sel=IETF
/8/
OpenMobility Diagnostic Tools
/9/
RFC 2131, Dynamic Host Configuration Protocol, March 1997
/10/
RFC 3164, The BSD Syslog Protocol, August 2001
Page 5
1 INTRODUCTION
01/2007
AMT/PTD/PBX/0062/1/2EN