Desired Cutting Values Under A, B, C Buttons - Selbit ISP - 010 Manual Handbook

After correct checking of all parameters described above, the controller is ready to use.
If there are any other reasons of controller's incorrect operating, please refer to chapter
12: "Possible errors and solutions".
Controller takes into account trace of the saw, cutting thickness displayed on the
screen is real cutting value of produced material. Next instructions describes cutting
methods available in this controller.
On the controller's panel there are three A, B, C buttons available. Please press one of them
shortly and there is a possibility to storage cutting value under each those buttons.
To storage often use cutting value in one of the button follow:
- reboot the controller
- while ISP-010 is displaying press one of the A, B, C button and there will be Abc text and
dashes shown on the screen
- next, please press again one of the button where the value will be saved, name of the value
is shown (A, B or C)
- type in the value and eventually press next button to store next cutting value
- After desired values save them using "Start/Next Cut button". "Save" confirm operation.
Controller's practical use
CHAPTER 4

Desired cutting values under A, B, C buttons

www.selbit.pl
- 14 -