Backward Feeding Saw Height Settings In Saw Up Function; Real Head Saw Height Above Main Track Settings - Selbit ISP - 010 Manual Handbook

will be a mistyping in providing the real value, please wait 3 seconds and start again. Please
type in value as follow: e.g. for giving 125 mm press 1-2-5 buttons. Next please storage the
parameter shortly pressing "Start/Next Cut". The save sign will confirm operation.
5 – Backward feeding saw height settings in Saw UP function
There is a possibility to program two separate modes of the backward feeding saw height
above cut material which are available during cutting, using UP and LO or HI mode buttons.
In normal mode (LO) after pressing UP button, controller rise up the head saw for about 12
mm above cut material. In this mode there is a need to take out cut material before going back
on the track's beginning with saw head.
In the second available mode (HI), controller rise up the head saw for about 12 mm plus value
of the just cut material. In this mode after cutting there is no need to take out cut material
before going back with the head saw on the beginning of the track.
Standard the controller operates in normal mode (LO).
To check or change mode please follow:
- reboot the controller for about 3 seconds
- when ISP-010 is displayed, please press and hole for about 3 seconds "Saw UP" button.
- on the upper scren the actual mode is show. LO text means normal mode where controller
feed up the head Saw for about 12 mm. "HI" says that controller operate in "Saw Up"
mode and it feed up the head saw for about 12 mm plus last cut value.
- To change modes, please use arrow buttons.
Please save mode with "Start/Next Cut" button.
-
www.selbit.pl
- 13 -