Checking And Eventually Changing Input Divider Correct Value; Saw Trace Value Checking - Selbit ISP - 010 Manual Handbook

Please notice that after setting up the input divider it is needed to
follow next starting instructions otherwise the controller will not
work properly.
To check and eventually change the value of the saw trace please hold for 3 seconds
button with saw symbol. The symbol of the saw trace and its value will be displayed. Now
there is a possibility to check and eventually change this value depends on the saw type used.
Typing in the saw trace please notice that the value is round off to one place after the come.
Example: if you want to type 2 mm first press 2 button and then 0. On the screen 2.0 value
will be displayed. After checking and eventually changing the value of the saw trace to save it
to the controller's memory pressing "Start/Next Cut" button. Text "Save" should be shown.
3 – Auto-calibration (controller's checking in with technical parameters of the sawing
2 – Saw trace value checking
frame machine where its mounted)
www.selbit.pl
- 11 -