Melec GD-5410 Instruction Manual page 32

１０－２．Conforming to Europe standards and UL standards
This product conducted the validation test of low voltage directive and EMC directive
with TÜV(TÜV Japan) for self-declaration of the CE making.
(1) Safety standards
EN50178
UL508C
●Low voltage directive
This product is designed for use as a built-in component.
・Install the product within an enclosure in order to avoid contact with the hand.
・Securely ground the protective earth terminals.
●Installation conditions
Protective class:
Overvoltage category:
Pollution degree:
Protective type:
Warning for UL standards
*1
This product has no provision for motor over temperature protection.
Motor over temperature protection is required in the end use product.
(2) EMC standards
EN 61000-6-2
EN 61000-6-4
EN 55011 Group 1 Class A
●EMC derective
This product conducted EMC measurement with the system configuration for EMC.
・EMC characteristic may vary depending on the configuration of the equipment that
contains the driver or stepping motor. Be sure to conduct EMC measurement with
the product assembled in your equipment.
Configuration
The metallic enclosure and shielded wires and ferrite core work to shield noise.
*1
EN50178
Ⅰ
Ⅱ
Class 2
IP-00
UL508C
Ⅰ
Ⅲ
Class 2
IP-00
-32-
Instructions Manual
R2