Enabling And Disabling Parksense; Service The Parksense Park Assist System - Jeep RENEGADE 2021 Owner's Manual

Table of Contents

Advertisement

128
STARTING AND OPERATING
Front Park Assist Audible Alerts
ParkSense will turn off the Front Park Assist
audible alert (chime) after approximately three
seconds when an obstacle has been detected,
and the vehicle is stationary. If the obstacle has
been detected within less than 12 inches
(30 cm), then the Parksense will not turn off the
Front Park Assist audible alert.
Adjustable Chime Volume Settings
Front and Rear chime volume settings can be
selected from the Customer-Programmable
Features section of the Uconnect system
Ú page 159.
If the Uconnect system is equipped, chime
volume settings will not be accessible from the
instrument cluster display.
The chime volume settings include low,
medium, and high. The factory default volume
setting is medium.
ParkSense will retain its last known
configuration state through ignition cycles.
E
A
D
NABLING
ND
ISABLING
ParkSense can be enabled and disabled with
the ParkSense switch, located on the switch
panel below the Uconnect display.
When the ParkSense switch is pushed
to disable the system, the instrument
cluster display Ú page 75 will show
the "ParkSense Disabled" message
for approximately five seconds.
The ParkSense switch LED turns on when the
system is disabled by pushing the switch, as
well as in case of failure or temporary disabling
conditions. The ParkSense switch LED will be
off when the system is enabled. If the
ParkSense switch is pushed, and requires
service, the ParkSense switch LED will blink
momentarily, and then the LED will be on.
P
S
S
T
ARK
ENSE
ERVICE
HE
S
YSTEM
When the ParkSense System has detected a
faulted condition, the instrument cluster display
will actuate a single chime, and it will show the
"PARKSENSE UNAVAILABLE WIPE REAR
SENSORS", "PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS", or the "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" message
for five seconds. Under this condition,
ParkSense will not operate.
If "PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" or "PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS" appears in the instrument
cluster display make sure the outer surface and
the underside of the rear fascia/bumper and/or
front fascia/bumper is clean and clear of snow,
ice, mud, dirt or other obstruction and then
cycle the ignition. If the message continues to
appear see an authorized dealer.
If the "PARKSENSE UNAVAILABLE SERVICE
REQUIRED" message appears in the instrument
cluster display, see an authorized dealer.
P
S
P
A
ARK
ENSE
ARK
SSIST

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents