Transmission Limp Home Mode - Jeep RENEGADE 2021 Owner's Manual

NOTE:
In AutoStick mode, the transmission will only
shift up or down when the driver moves the gear
selector rearward (+) or forward (-), except as
described below:
The transmission will automatically upshift

when necessary to prevent engine over-
speed.
The transmission will automatically down-

shift as the vehicle slows (to prevent engine
lugging) and will display the current gear.
The transmission will automatically down-

shift to FIRST or SECOND gear (depending on
model) when coming to a stop. After a stop,
the driver should manually upshift (+) the
transmission as the vehicle is accelerated.
You can start out (from a stop) in FIRST or

SECOND gear. Starting out in SECOND gear
can be helpful in snow or icy conditions. Tap
the gear selector forward or rearward to
select the desired gear after the vehicle is
brought to a stop.
If a requested downshift would cause the

engine to overspeed, that shift will not occur.
The system will ignore attempts to upshift at

too low of a vehicle speed.
Avoid using Cruise Control when AutoStick is

engaged because the transmission will not
shift automatically.
Transmission shifting will be more noticeable

when AutoStick is enabled.
The system may revert to automatic shift

mode if a fault or overheat condition is
detected.
To disengage AutoStick mode, return the gear
selector to the DRIVE position. You can shift in
or out of the AutoStick position at any time
without taking your foot off the accelerator
pedal.
WARNING!
Do not downshift for additional engine
braking on a slippery surface. The drive
wheels could lose their grip and the vehicle
could skid, causing a collision or personal
injury.
STARTING AND OPERATING
T L H
RANSMISSION IMP OME
Transmission function is electronically
monitored for abnormal conditions. If a
condition is detected that could result in
transmission damage, Transmission Limp
Home Mode is activated. In this mode, the
transmission may operate only in a fixed gear,
or may remain in neutral. The Malfunction
Indicator Light (MIL) may be illuminated. Limp
Home Mode may allow the vehicle to be driven
to an authorized dealer for service without
damaging the transmission.
In the event of a momentary problem, the
transmission can be reset to regain all forward
gears by performing the following steps:
1. Stop the vehicle.
2. Shift the transmission into PARK, if
possible. If not, shift the transmission to
NEUTRAL.
3. Push and hold the ignition switch until the
engine turns off.
4. Wait approximately 30 seconds.
105
M
ODE
4