AEG Thyro-E Series Operating Instructions Manual page 17

Installation Operations Manual Thyro Power Manager
control inputs
Earth connection (to the lamps)
Output L1 / phase to the lamps
Output N / neutral to the lamps
Input N / neutral from the mains
Input (switched) L1 / phase from the mains, for the lamps
Earth connection (from the mains)
Input (permanent) L1 / phase from the mains, for the timer
Figure 4: Terminal block
The following Figure 5 shows the connection of a Thyro-E system with integrated timer. In
this case, the control inputs do not have to be connected. If a permanent supply of 230V~ is
available in the connection range, it can be used for the power supply of the timer. If not, the
connection diagram Figure 6 should be used. If the system is switched off, the power supply
of the timer is ensured by the installed battery.
Page 18 of 18 Version: 1.7.2009 8000022632 BAL, EN