Welch Allyn Spot Vital Signs LXi Repair Procedure page 6

To configure 802.11a/b/g radio for WPA2-AES and download client
certificates
1. Set up a local AP as "open" with desired SSID.
2. Connect Spot LXi and Radio as described in 802.11a/b/g Radio Configuration section above, and open the LXi Radio
Configuration Utility. Set Wireless Security Mode to "Disabled" and then input SSID used on the AP.
3. Click on Ping Radio and get the radio IP address.
4. Open up Internet Explorer and input the radio's IP address in the address bar and press Enter Key. This will open a web page
using the IP address of the radio.
5. Login as admin with password webpassword1234.
6. Navigate to the Auth-> Certificate Status and Configuration page.
7. Click on "Upload Customer Device Certificate and Key" and follow instructions.
8. Navigate back to Webadmin-> EAP parameters.Make the desired selection. Select Submit.
9. Navigate back to Webadmin ->Authentication and Encryption. Select WPA2-AES and select Submit.
10. Verify that the network infrastructure is in place for WPA2-AES and power cycle the LXI.
11. LXI should authenticate using WPA2- AES and be able to send data to the network.
Prepare the Spot Vital Signs LXi for patient use
1. Remove null modem and serial cable from Port 1 and connect the bar code reader to Port 1.
2. Re-configure the Spot Vital Signs LXi (see
the External Devices menu screen settings to the following:
3. Press the Power button to turn the Spot Vital Signs LXi off.
"Installing the Spot LXi Radio Configuration software" Step 6
Information System
Barcode Patient ID
Barcode Clinician ID
Weight Scale
Wireless Module
Printer
On
On
Off
Off
DPAC
Off
and Step 7). Change
6 of 9