Welch Allyn Spot Vital Signs LXi Repair Procedure page 5

Confirming Radio configuration
1. Verify the connection on the Spot LXi to the Radio as in
Note Step 2 applies to the 802.11b radio only.
2. Verify the Radio light status (Power = green, Link = green, Comm = red). If the radio lights do not match after approximately 1
minute, verify the radio configuration and wireless router settings.
LED LED Color
Power Off
Red
Amber
Green
Link Off
Red
Green
Comm Off
Red
Blinking Red
Amber
Blinking Green
Green
3. From the Spot Vital Signs LXi radio configuration tool click Ping Radio.
4. Verify the statistics.
Microsoft Windows XP [Version 5.1.2600]
(C) Copyright 1985-2001 Microsoft Corp.
C:\>ping 10.19.36.237
Pinging 10.19.36.237 with 32 bytes of data:
Reply from 10.19.36.237: bytes=32 time=1ms TTL=127
Reply from 10.19.36.237: bytes=32 time=1ms TTL=127
Ping statistics for 10.19.36.237:
Packets: Sent = 2, Received = 2, Lost = 0 (0%
loss),
Approximate round trip times in milli-seconds:
Minimum = 1ms, Maximum = 1ms, Average = 1ms
C:\>
5. Click OK, click Close. Then click OK.
6. Click on the printer icon and make 2 copies of the form within the configuration tool. Give one copy to the customer and the
other goes into the Connex installation package for Welch Allyn, if applicable.
Step 9
Function
Bridge is not receiving power.
Bridge failed its Power On Self Test (POST) and is not configured for wireless communication.
Bridge passed its POST but is not configured for wireless communication.
Bridge passed its POST and is configured for wireless communication.
Bridge is not receiving power.
Bridge is searching for an Access Point.
Wireless network and MAC have associated with an Access Point.
No power or no wireless TCP session is established and no physical serial connection is detected.
No wireless TCP session is established; a physical connection is detected.
A physical serial connection was detected and there is serial traffic present on that connection, but no
wireless TCP session is established.
A wireless TCP connection is established but no physical serial connection is detected (i.e. no serial cable is
attached to the Bridge).
A wireless TCP session is established, a physical serial connection is detected, and the Bridge is transmitting
or receiving data across the wired serial port.
A wireless TCP session is established, a physical serial connection is detected, but there is no active data
movement across the wired serial port.
and Step 10.
Sample Screen Capture
Acceptable packets lost = 0 Any lost
packets require you to check the
configurations.
5 of 9