Mercedes-Benz Sprinter Operating Instructions Manual page 192

190 Transporting
To move the rack rails: unscrew star knobs
#
7 counter-clockwise until they are slightly
loose.
Slide rack rail 2 along roof rail
#
desired position.
Screw star knobs 7
#
Check that the rack rail is seated securely.
#
Moving the sliders
& WARNING Risk of injury due to inade‐
quately secured loads
If the slider of the interior roof rack system is
not engaged properly, the load may come
loose, fall down and injure people, for
instance when they enter or load and unload
the cargo compartment.
Always engage the slider properly.
#
%
Ring 8 of slider 4
angle of 90° to rack rail 2, so that slider
is engaged properly.
When the ring of the slider is at an angle
#
of 90° to the rack rail: pull ring
4 down and simultaneously move slider
to the desired position.
Release ring 8 at the desired position.
#
Move slider 4 slightly further along on rack
#
rail 2 until slider
When the ring of the slider is parallel to
#
the rack rail: move slider
position.
Position ring 8 of slider
#
90° to rack rail 2.
Slider 4 is engaged.
1 to the
tight clockwise.
must always be at an
8 of slider
4 engages automatically.
4 to the desired
4 at an angle of
Adjusting the belt strap
Press and hold the locking mechanism on
#
slider 9.
Pull or release belt strap 5.
#
Release the locking mechanism on slider 9.
#
%
When securing or loosening a load, be sure
to not stand under the load.
Securing and loosening the load
To secure the load: place the load in the belt
#
straps of the rack rails.
Fasten the load flush with the partition.
#
Secure belt strap 5.
#
Check that the load is seated securely.
#
To loosen the load: press and hold the lock‐
#
ing mechanism on slider 9.
Pull ring 8
#
ously move the slider away from the load.
4
Loosen belt strap
#
make sure that the load does not fall out of
the belt straps.
Remove the load from the belt straps.
#
4
Installing cargo tie down rings
of the slider down and simultane‐
5 and at the same time