Mercedes-Benz Sprinter Operating Instructions Manual page 132

130 Driving and parking
Electronic level control starts automatically if the
ignition is switched on. Operation is only possible
after the parking brake has been applied.
Electronic level control performs a self-check reg‐
ularly when it is activated and while in use. Indi‐
cator lamp 7 on the remote control lights up for
about one second when you switch on the igni‐
tion.
There is a malfunction if indicator lamp
behaves in the following ways:
The indicator lamp does not light up when you
R
switch on the ignition.
or
The indicator lamp then lights up again or
R
flashes.
In addition, a warning tone is emitted from the
remote control for approximately 30 seconds.
The fault that has been detected can be shown
using the indicator lamps (signaling of fault
codes).
Park the vehicle, leaving the ignition switched
#
on.
Apply the parking brake.
#
To raise or lower the vehicle level: press
#
and hold button 4
level reaches the required height.
The indicator lamp in button
as long as the vehicle level is being changed.
When the vehicle level has been set, the indi‐
cator lamp in button
To lower automatically: briefly press button
#
5.
Electronic level control automatically lowers
the vehicle to the next lower position:
From the highest position to driving level
R
From driving level to the lowest position
R
The indicator lamp in button
long as the vehicle level is being changed.
7
or 5 until the vehicle
4 or 5 flashes
4 or 5 lights up.
5 flashes as
When the vehicle level has been set, the indi‐
cator lamp in button
%
By pressing button
the original position will be reset.
To raise automatically: briefly press button
#
4.
Electronic level control automatically raises
the vehicle to the next higher position:
From the lowest position to driving level
R
From driving level to the highest position
R
The indicator lamp in button
long as the vehicle level is being changed.
When the vehicle level has been set, the indi‐
cator lamp in button
%
By pressing button
the original position will be reset.
To raise or lower automatically to driving
#
level (center position): press and hold but‐
ton 6.
Electronic level control automatically raises or
lowers the vehicle to driving level.
To save the set vehicle level: set the
#
required vehicle level.
Press and hold button
#
a tone.
The vehicle level set has been saved on corre‐
sponding button 1
To call up the saved vehicle level: briefly
#
press button 1 or 2.
Electronic level control automatically raises or
lowers the vehicle to the saved driving level.
The indicator lamp in button
as long as the vehicle level is being changed.
When the vehicle level has been set, the indi‐
cator lamp in button
%
Service mode may only be activated or deac‐
tivated at a qualified specialist workshop by
trained personnel. In service mode, the air
suspension system is deactivated for mainte‐
nance or fault detection.
To activate service mode: press button 3.
#
Service mode is active and the indicator lamp
in button 3 lights up continuously.
To deactivate service mode: press button
#
3.
Service mode is deactivated and the indicator
lamp in button 3
5 lights up.
4 during the movement,
4 flashes as
4 lights up.
5 during the movement,
1 or 2 until you hear
or 2.
1 or 2 flashes
1 or 2 lights up.
goes out.